Vintage Mustang Forums banner

Supplier For Sway Bar Bushings

693 Views 2 Replies 2 Participants Last post by  Guest
Anyone know a supplier for 1/2" rear and 15/16" front sway bar bushings for a 70 mach. I would perfer polyurethane but at this point would accept rubber. I would also like to retain the original brackets if possible.

Mark Memmer
70 Calypso Coral Mach 1 351C 4V Completed by 8/01
98 Cobra Convertible
93 5.0 Mustang LX (Winter Ride)
00 Volvo S80 (Wifes Ride)
1 - 1 of 3 Posts
Last set I bought came from Jegs Hi Performance.... Energy Suspension was the brand I recall......

Required tools for operating a Vintage Mustang:
1. Duct Tape
2. J.B. Weld
3. B.F.H. (Big Fat Hammer)
View Album Here:
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.