Vintage Mustang Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,078 Posts
Discussion Starter · #1 ·
Can anyone tell me the working travel distance (up and down) of the front suspension? It should be somewhere between 4" and 6", correct? If it matters, I'm looking at a '65 Coupe.

Thanks,

Al

Turd's Rule!!
 

·
Supporting Vendor
Joined
·
3,961 Posts
It depends on how low your car is. You can check yourself by
using a tape measure and go from the upper a-arm above the
ball joint to the stop. Same in the rear. My '65 is pretty low
and I don't think there is 5" of travel.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top