Temp and Oil Pressure Gauges no work.
Join the discussion
Recommended Reading
-
Issue with upper control arm removal :/
Vintage Mustang ForumHi Guys, I seemed to have run into an issue regarding the coil spring and removing the upper control arm on my '68. Can I use a macpherson spring compressor to pull up the bottom coil?- 23
- 343
-
Will Eldelbrock Air Gap Intake #7581 on my 351w fit under a 69 mustang stock hood?
Vintage Mustang ForumI purchased Eldelbrock top end kit #2092 for my 351w in my 69 mustang. But in reading the fine print I learned this may not fit using a stock hood on some mustang models. I called and they said the kit comes with an air Gap intake that's 5.75 height. I ask about using a dropped air cleaner, They...- 3
- 111
-
Radial Tires on stock rims
Vintage Mustang ForumI have been running P185-75R14 radial tires on my '66 coupe with stock wheels (14 x 6) for almost 9 years with no problems. I would like to upgrade to a larger tire. What, in your experience, is the largest tire that could be installed on these wheels safely? I'm sure I could go to a P195-75R14...- 6
- 185
-
How to avoid a money pit... (disregard title)
Vintage Mustang ForumOk I’m going to try and make this very loaded question alittle less loaded. Right now I’m a college student on a hard budget. Makes things difficult. I’ve heard so many say they wish they dropped the cash on this or that instead of cheaping out. I want to know where I can cheap out and where I...- 112
- 2K
-
Jr_Palm · updated
-
Carburetor Rebuild
Vintage Mustang ForumI bought my '66 289 in April. It is a very original car. Looks good, runs good. In going thru everything I did notice that the carburetor had been replaced with what looks like an early 70's, '72 or '73, truck carburetor. I have tracked down a 2100 with a correct time frame tag thru FaceBook...- 12
- 312
Join now to ask and comment!