G
Guest
·Guest
Joined
·
0 Posts
Just testing out the what the signature thing is.....
It's my pony and I'll buy if I want to...
It's my pony and I'll buy if I want to...
Test
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Virtual Mustang Car Show
Vintage Mustang ForumThe engine bay thread got me thinking... it's nice to put a car to the screen names. On a car forum a pic of your engine bay is like a glimpse into your soul. But what about the rest of the car? Here's the rules. Three pictures: exterior, interior, engine bay. Any angle is fine. If you do some...- 14
- 267
-
jdub · updated
-
302 buy build
Vintage Mustang Forumhi, i just picked up a 95 302 roller block. It has been bored .30 over, has flat top pistons, Edelbrock Performer heads, E303 cam. The rotating assembly was balanced. It has roller tip rockers. i need to buy an intake, distributor, carb and everything else. this is going to get my butt moving...- 6
- 126
-
jtaoj · updated
-
Bleeding brakes. Frustrated, got to vent.
Vintage Mustang ForumSo I'm trying to bleed my brakes after replacing my master cylinder. I got a 65 6 cylinder with four wheel drums. I've gone around the car 5 times trying to get the brakes bled. I'm doing it with my wife doing the press, open, close, release method and got out all the big bubbles I could see...- 30
- 1K
-
Best interior HEAT insulation?
Vintage Mustang ForumWhat is the best "heat" insulation for the interior? There are COUNTLESS threads on sound deadeners, but my understanding is that sound deadeners are different from heat insulation (or school me if I'm wrong). In my 1-hour commute each way every day, the interior gets pretty toasty and the...- 20
- 9K
-
Rorin67 · updated
-
Show me your engine bay!!
Vintage Mustang ForumSince my car is in pieces and I’m going to rebuild the 289, I need to get some ideas on how to “dress” the engine bay. I don’t want to end up with an abomination of blue, red, yellow, black and chrome - so pop your hoods! I’ll get it started ;)- 68
- 2K
-
67_ksb · updated
Join now to ask and comment!