Vintage Mustang Forums banner

tires and wheels HELP

Jump to Latest Follow

1 - 2 of 2 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter • #1 •
Well thanks for all the feedback on my previous post about me upgrades, it seems everyone was more interested in commenting on Tangdar's flintsone mobile. But anyway I need so input on wheels and tire sizes. Currently have steel styled wheels 14 inch with some new radial t/as and haven't decided if I should go to the Magnums 15x7 or go to the Vintage 45 or 48s 16x7, If I choose the magnums what size tires can I run? I am 1inch lower in front and back. Thanks again for the input.
 
66emberglow

·
Registered
Joined
·
5,527 Posts
#2 •
Or you could go with 15x7 Styled Steel wheels, with some 225/60/15 tires all the way around. Looks great.


Coppertone's current condition:
http://www.knology.net/~dorner/images/coppertone2.jpg
 
1 - 2 of 2 Posts
Recommended Reading
Read More

  1. 1965 Power Steering leak question

    Vintage Mustang Forum
    My new to me 1965 convertible has a power steering leak, I think this is a fairly common problem. The control valve is leaking. My question is should I remove it and install a rebuild kit, or just replace it. It seems to be a bit pricy at over $300, a good kit is around $70. Just want to...

  2. Overheating 66’ GT

    Vintage Mustang Forum
    Hi folks My 66 Mustang GT is running high on the temp gauge and today blew down for 30 seconds after I shut it off, making a fine sound during the event. Car ran fine, otherwise. It’s the original 289 but the radiator has been replaced. I’m assuming a bad water pump. Not sure that has ever been...

  3. FMX Hesitates Going Into 3rd Gear with Heavy Foot

    Vintage Mustang Forum
    1971 Mach1 351C with FMX. Grabber yellow with Mach1 flat black treatment and stripes. Great car! I bought the transmission used for $250 and it works/shifts fine when I drive car normally, however if I jump on it or punch it, the tranny slips and engine revs up for about a second before shifting...

  5. Clutch z bar install

    Vintage Mustang Forum
    I just got the new T5 tranny in and I’m moving on to hooking up the z-bar linkage. I have everything loosely in for measurements but I’m stuck with the lower rod that engages the clutch fork. How do I move the clutch fork back far enough to let me install the rod? It can’t be done with your bare...

  6. Show me your trunk!!

    Vintage Mustang Forum
    I'm looking for ideas to spruce up my bare metal trunk. I'm not keen on dropping 500 bucks for the plastic and fabric MTF kit, so I'll make my own. No tire in there for me =) BTW, anybody have suggestions of what carpet to use? I'm thinking plywood core panels wrapped in carpet ... unless you...
Read More
About this Discussion
1 Reply
1 Participant
Last post:
66emberglow
Vintage Mustang Forums
A forum community dedicated to vintage Ford Mustang owners and enthusiasts. Come join the discussion about restoration, modifications, NOS parts, troubleshooting, VIN codes, and more!
Full Forum Listing
Explore Our Forums
Vintage Mustang Forum General Discussion (Non-Vintage Mustang) Mod and Custom Forum Classic Mustang Wanted Ads Concours Forum
Popular Communities
Community avatar for Home Entertainment
Home Entertainment
1,280,000+ members
Join
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Working From Home Forum - New!
Working From Home Forum - New!
25+ members
Join
Top