G
Guest
·Guest
Joined
·
0 Posts
I have a '66 GT, would GT be somewhere on the title if it was a factory GT?
Title info
1 - 3 of 3 Posts
G
Guest
·Guest
Joined
·
0 Posts
nope, just on the vin info.
Joined
·
19,169 Posts
GT designation on 65/66's were not on VIN, Door tag, or any other tag, with the exception of Metuchen-built cars that came with Buck Tags. These were found on the driver's side fender apron, and the Buck Tag should read PIO (Performance Image Option).
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Ford Warranty. Unhappy customer.
Vintage Mustang ForumTo whom it may concern at Ford Motor Company Customer service. In the event anyone from Ford see's this thread. Recently. The water pump on my wife's 2014 Mustang failed. We purchased an extended warranty when we bought the car new. Her car is past the mileage of the standard warranty but is...- 1
- 0
-
1969sag · updated
-
Car cover
Vintage Mustang ForumI know it’s bad to cover a car in moist weather. But I need to move my convertible mustang out of the garage for 2 weeks so the bathroom remodelers can use the garage for their work. Do you think 2 weeks with some rain with a covered car will result in mold issues? Or with the short time...- 3
- 186
-
DrVett · updated
-
Starting engine out of car?
Vintage Mustang ForumI just bought an engine from a guy that says it runs good. I have on test stand and I would like to start it. Can you guys tell me if I'm thinking right and if I should be careful about anything. 1. The engine is secure on the stand - I even have some straps to make sure it does not move...- 4
- 98
-
Late model transmission swap to 65 mustang
Vintage Mustang ForumI am starting a restoration on my 65 mustang. Am wondering if anyone can tell me if a late model mustang (90's) manual trans will fit without modification into a 65. Am wanting to switch over the late model motor trans and rear end to the 65. Seems like a reasonably priced idea. Thanks or any...- 0
- 0
-
Recommendations for a New Driveshaft?
Vintage Mustang ForumAfter reading this .pdf from a 2014 post on this board I'm fairly sure that a standard 289 v8 coupe came with the rubber isolated drive shaft. Starting to lean towards putting re-balancing money (100-150$) towards a new driveshaft while pursuing other avenues of the vibrations. I've found that...- 26
- 436
-
jsbenami · updated
Join now to ask and comment!