Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
678 Posts
Discussion Starter #1
I have a toploader that started leaking. It seems to be coming out the front of the transmission. Are there any seals on the input shaft ? If so where would they be, is it the bearing itself?
 

·
Registered
Joined
·
4,670 Posts
There is a seal in the bearing retainer. Take the 4 bolts off pull the retainer off and you will see it.


69 Mach 1 427 Windsor
 

·
Registered
Joined
·
5,368 Posts
It could also be the cluster pin which runs through the trans and the front end presses into the front of the case from the inside.
Usually has a swipe of silicone over the very end. If your leak is there it's usually the case that has worn out and not the pin itself. Rare, but it happens.
 
1 - 3 of 3 Posts
Top