Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part August's Ride of the Month Challenge!
1 - 2 of 2 Posts

Discussion Starter · #1 ·
i have searched the shop manual and it's not here...
how tight should those bolts be on the engine mount brackets? i had to take off an insulator, and i dont want anything shaking loose.
mike o

[color:blue]'65 wimbledon white original coupe I6
'99 silver convertible V6

Check out Mike & Jackie's '65 Mustang </font color=blue>

1,669 Posts
Torque specs are; support bracket to body attach bolts to 20-30 ft lbs, insulator to support bracket attach bolt to 25-40 ft lbs, and insulator to engine attach bolts to 25-40 ft lbs.

65 Hi-Po F/B (7 yr resto)
67 GTA F/B (small block) Mustang Owners Club of Austin (MOCA), TX
MCA 27479
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.