Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6,031 Posts
Discussion Starter #1
I dont even have to say anything... I just have to post this:

http://mywebpages.comcast.net/jcmeyer5/current/liftit.jpg

I got the old crap-box out. I also got the new block plate and flexplate installed. The flexplate took some finesse... the center hole wasnt quite big enough. I couldnt get one bolt started. A little die grinder action fixed it. The other was that the torque convertor studs werent sliding into the flexplate very well at all... it would have taken some brute force to get it to work. A file and a few minutes later I have a nice snug fit, but loose enough that it wont bind when installing.

Oh... I cheated and rented a tranny jack. Sue me.

My wife even got in on the act!

http://mywebpages.comcast.net/jcmeyer5/current/wifey.jpg
 

·
Registered
Joined
·
1,117 Posts
ya but you have a hoist !!!!
 

·
Registered
Joined
·
2,987 Posts
I must say, You look like you really got your butt kicked. And I would say the pretty young lady in the other pic did the kicking!!!!!!
Deb cracked up laughing when she say your picture!!!
 
1 - 6 of 6 Posts
Top