Vintage Mustang Forums banner

1 - 3 of 3 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
OK, I got these great original trans cooling lines that are all pre-bent and look very nice. The problem is that since the ones I took off were Mickey Mouse rubber hoses, I don't know the proper routing of the new lines and can't find a pic anywhere. I have a 66 with a 302/c-4. Any help would be greatly appreciated.
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #2
I just went through this and it took me a couple times to get it right. ALhtough they look like they go over this and under that, they go over everything. Over the center drag link, over the crossbar brace and over the front sway bar, all on the passenger side of the engine. I put mine in from the bottom rear and worked them forward. Good luck!
 
G

·
Guest
Joined
·
0 Posts
Discussion Starter #3
Thanks a lot. I think I just might drop the sway bar and brace because they need painting anyway. That will make it a lot easier.
 
1 - 3 of 3 Posts
Top