Tremec 3550 question
1 - 3 of 3 Posts
Joined
·
6,911 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Recommendations for a New Driveshaft?
Vintage Mustang ForumAfter reading this .pdf from a 2014 post on this board I'm fairly sure that a standard 289 v8 coupe came with the rubber isolated drive shaft. Starting to lean towards putting re-balancing money (100-150$) towards a new driveshaft while pursuing other avenues of the vibrations. I've found that...- 28
- 569
-
jsbenami · updated
-
Cold start and fast RPM
Vintage Mustang ForumWith this car being my first carburetor engine vehicle, I finally found the sweet spot with cold starts. Tap on the gas pedal 3 times and start the car. The auto choke does its job. My fast RPM sits at 1,600. I give the gas pedal a tap after a minute and it idles at 900. I'm wondering if 1,600...- 4
- 72
-
Razzle1980 · updated
-
Shifter problem help please
Vintage Mustang ForumOk. Let me give you the run down.... 1. I have a 1965 Mustang 6 cyl 3 speed 2.77 transmission. Removed the tired engine and transmission. 2. Bought a 1966 Mustang 6 cyl 3 speed 3.03 transmission set up with a 1969 shifter rods and 1969 shifter. I placed the 1966 set up into my 1965, but...- 1
- 16
-
ILuv65FB · updated
-
Middle headlights on 69 not working
Vintage Mustang ForumHi guys, This is probably a dumb question... So I just realized the two middle headlights in my 69 coupe is not working. Are those two considered the high beam lights? Is there a specific way to turn it on? As far as I know, there are two stages when I pull the light switch and that's it. Even...- 15
- 266
-
Need User Images for New Banner(4 years ago)
Vintage Mustang ForumPost away if you want to be in the new site banner. Prefer high resolution images with no open doors, windows, hoods. High and low angels with no obstructions or shadows. Post them up here and we will try to work them into the upgrade. Jeff- 156
- 1M
-
Administrator · updated
Join now to ask and comment!