Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part MAY's Ride of the Month Challenge!

1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
A few weeks back my left TS stopped working. I traced it to a bad TS switch in the steering column. I managed to locate a replacement from Scott Drake, however there are a couple differences - CS8A instead of CZ8A and there are two extra wires (a gray and a yellow with blk stripe). These extra wires seem to oppose each other and there's evidence these were even cast in my original part although there was no wire or contact.

Anone know what these two wires are for? I'm tempted to clip them out and "go".

Randy
 
G

·
Discussion Starter · #2 ·
You are right, just do not use them. They are there for some other application is all. Make sure you have all the other colors matched up and forget about the extra wires.
 
1 - 2 of 2 Posts
Top