Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part JUNE's Ride of the Month Challenge!
  • May's Ride of the Month contest ended with a tie! Go to this thread to vote on the winner! VOTE HERE

1 - 2 of 2 Posts

·
Registered
Joined
·
65 Posts
Discussion Starter · #1 ·
More garage cleaning, this time two tie rod ends from a Unisteer rack on a 1965 Mustang. These rods are used on the 1965 rack, but also other Unisteer models. The rubber boots went out and I purchased a new set of ends so these are the old ones that come with the correct set of energy suspension tie-rod end boots and a fresh pair of cotter pins (MSRP $8.66). Note that this earlier model used a castle nut (pictured) where as the newer model uses a fiber nut which could also be used depending on the look you are after. Unisteer part number is 8021320 and are sold $45/each new. PM if interested and I will send them to you asking that you make a donation to my Paypal.

754354
 
1 - 2 of 2 Posts
Top