Vintage Mustang Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1,106 Posts
Discussion Starter #1
Over the long weekend, I installed my roller cam motor and T5 trans. Went in easily. Biggest problem was that I had to elongate the holes in the trans mount I purchased for the T5. I used the original 66 drive shaft and transferred the nose part (that goes into the trans) from an 85 drive shaft. Installed new U joints while I was at it. Hope to have it running later this week. Photos to follow.
 
1 - 1 of 1 Posts
Top