Vintage Mustang Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
251 Posts
Discussion Starter · #1 ·
HELP!!! I'm converting my automatic fastback to a 4-spd and just realized that I need a clutch rod release spring bracket to complete the linkage setup. This bracket is used to hook the release spring attached to the equalizer bar to the firewall. It slides through a narrow slot located just below the master cylinder in the firewall. If you're parting out a car or have this piece please contact me..

[email protected]
I'm in northern VA.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top