Joined
·
3,894 Posts
I am thinking about buying these babies on e__y.
Is any other VMFer after them? If so, PM me, and I'll back off.
Is any other VMFer after them? If so, PM me, and I'll back off.
Weber 48 IDAs, anybody after them
1 - 2 of 2 Posts
Joined
·
925 Posts
I have them as a watch item but I'm just curious to see if it makes reserve. (the manifold, too!) Good luck!
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Cowl Swiss cheese
Vintage Mustang ForumA few holes on drivers side cowl. I’m thinking repairing, applying platinum rust encapsulator and closing up. This car (while I own it) will never see rain. I can see all around the hat and the out board side of the cowl is the worst, but I think I can close up these holes. The rest of...- 14
- 456
-
67six · updated
-
Life left in these brakes?
Vintage Mustang ForumHi all, So in my road worthiness inspection here in Frenchland, (among other things) they found that my rear brakes were ummmm, lacking. Like achieving 20% of the min acceptable =/ And the emergency break was non functional. ¯\(ツ)/¯ So I'm digging into the breaks. This car is a daily...- 8
- 169
-
DoctorC · updated
-
Need help selecting a dark blue color for my 68 FB (pics inside)
Vintage Mustang ForumHey all, My boys and I just dropped off our Mustang at the painter this past weekend. It was a super exciting step for us. This car was a driver when we bought it 16 months ago and we completely disassembled it, cleaned it up, and finally dropped it off. It's been quite a journey. I've...- 28
- 617
-
Upper control arm differences?
Vintage Mustang ForumI had the car inspected and I was told that the ball joints are bad and that I should probably replace the upper control arms as well. My question is, what are the differences in all of the available non tubular style arms? Will some allow better wheel clearance? I'm going to finally do the...- 3
- 173
-
What distributor gear are you using?
Vintage Mustang ForumSo like a million other people on the planet I have been going round and round trying to figure out the proper distributor gear to get. I have a billet cam but it's made from 5150 steel not 8620. I don't want to use a bronze gear. thinking melonite one or composite. I trust real world advice on...- 3
- 124
-
Ron French · updated
Join now to ask and comment!