what day at dallas swap meet?
Join the discussion
Recommended Reading
-
How Bad is my Camber?
Vintage Mustang ForumLook at that front wheel. Is this normal? Does this mean my Shelby drop is way overdue?- 3
- 76
-
umangu · updated
-
Question about harmonic balancers
Vintage Mustang ForumHi, guys! What is the difference between a harmonic balancer for 1965-1968 for 289 and 1969-1973 for 302? Both are 3 bolt. Aren't they both 28oz.? I see webshops sell them as "1965-1968 289" and then "1969-1973 302". Two different products and different prices. I thought they were the same. If...- 0
- 20
-
70 Mach 1 door molding
Vintage Mustang ForumIs the molding that attaches to the bottom of the drivers door supposed to have holes drilled out? I recently bought the car. It was painted but either holes in door were filled in or they replaced the door (can’t recall). Anyway it’s the only molding not on the car and I want to install it but...- 3
- 85
-
Cooling issue
Vintage Mustang ForumI'm back - because you guys are so helpful - I searched and didn't see a solution so I'll ask it here. Setup - I have a new radiator, upper and lower cooling hose, and transmission cooling connecting hoses. I filled the radiator with 50/50 and made sure there were no visible leaks at any of...- 12
- 258
-
trippme · updated
-
New mechanical fuel pump needed
Vintage Mustang ForumMy fuel pump took a dump this morning. It was one that I got from Speedway that had NPT fittings on both the intake and output sides as I run AN lines. I am looking at this as a replacement: https://www.summitracing.com/parts/crt-m60454 Any recommendations for something better...- 5
- 154
-
66coupe289 · updated
Join now to ask and comment!