Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
683 Posts
Discussion Starter #1
While replacing my heater hoses I managed to lose on of the four nuts that hold the heater motor in place on the firewall. So that I may just stop and pick one up at the store what size nut should I ask for?
 

·
Registered
Joined
·
5,773 Posts
A quick guess is a #10, but not sure if it's 10-32 or 10-24. Outside chance they are 1/4" nuts, I'd get some of each as you'll need more somwhere else and they're real cheap. See if anyone else answers.
 

·
Registered
Joined
·
683 Posts
Discussion Starter #4
Thanks KB97. I will take care of it.
 

·
Registered
Joined
·
5,674 Posts
From your sig "At least trying to make it original "

376842-S - stamped self threading hex flange w/sealer - 1/4" 7/16 hex. AMK part B-12982 - 6 pcs $3.
 

·
Registered
Joined
·
683 Posts
Discussion Starter #6
I really appreciate your input about the AMK material. I checked their website and they have a minimum order of $30 and shipping of $7. I would like to use an original nut but that is a little high for me.

Thanks again
 
1 - 6 of 6 Posts
Top