Whats it Worth??
1 - 2 of 2 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Turn signal woes
Vintage Mustang ForumI've been trying to figure out why my turn signals on the 68 coupe (302, T5, fixed column) won't work. The brakes, emergency flashers and front parking lights all work. But none of the turn signals do. I installed a sequential LED taillight kit (replaced the relay with this kit, turn signals...- 12
- 287
-
Bump Stop
Vintage Mustang ForumI crawled under the 67 this morning to see about taking the single six cylinder exhaust off. The pipes are welded, the muff is welded, the hangers are welded. Its not going to be a sawzall through the bend over the axle pipe and pull it out. Anyway, Im thinking about pulling the 67 rear end...- 3
- 95
-
bmcgc · updated
-
Front sway bar question
Vintage Mustang ForumI have a 1 inch front sway bar on my 66. The bolt on the lower control arm that goes through the sway bar and the sway bar are not at a 90 degree angle to each other. This is causing it to want to push the rubber insulators out. I did use the Ford style insulators, Not the hard ones that came...- 4
- 81
-
Parking brake assembly
Vintage Mustang ForumHow do I remove the cable from the handle assembly? Its tough to wiggle on your back under there and figure it out.- 5
- 80
-
bmcgc · updated
-
Voltage drop
Vintage Mustang ForumI have a 100 amp alternator from NPD. Charges the battery fine as I check the battery voltage regularly (12.6 volts) when the engine is off. When I idle at a stop light in gear my rpms are around 400. The voltmeter shows a drop to 12.5-13.5. If I put the car in neutral so the rpms increase to...- 5
- 54
-
DrVett · updated
Join now to ask and comment!