Vintage Mustang Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter #1
High lighted in red in attached pic.

The pieces themselves are good, the tabs/screws are just broken.

I've looked around, and can only find it in kits with the chrome piece.
 

Attachments

·
Registered
Joined
·
1,885 Posts
These two look like likely candidates (I don't have a fastback to compare to):
 

·
Registered
Joined
·
572 Posts
It was the first link! Thank you!
While the nylon part and stud are very similar to the originals, the fastener (nut) shown is not. According to both the Body Assembly Manual and the 1960-68 MPC Illustrations Section show that the nuts on the trunk molding should be 8-32 Stamped Acorn Nuts (377522-S100), and the two side pieces should be 8-32, Stamped Hex(PAL) nuts (45203-S36).

Both of these may be available from AMK (I can't check right now as their site is showing an "Error").

Bob
 
1 - 6 of 6 Posts
Top