Who would have thought a wiper switch would be this hard to locate!!! I hate replacing electrical parts with used parts ... I like to replace them with at least refurbished parts, if not brand new, but NOONE seems to carry a wiper switch for a '69, and the one for my sportsroof is half gone. Anybody know where to get one at or close to a reasonable price?
Where to get '69 Wiper Switch?
1 - 3 of 3 Posts
Joined
·
3,438 Posts
Try Ray Powers. He's a classified section seller under the id 9F02R100011. He's had stuff that no one else had for my '69 Mach and convertible. In fact, I just went over to his house and picked up all the parts I need for my drum to disc brake conversion.
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Bump Stop
Vintage Mustang ForumI crawled under the 67 this morning to see about taking the single six cylinder exhaust off. The pipes are welded, the muff is welded, the hangers are welded. Its not going to be a sawzall through the bend over the axle pipe and pull it out. Anyway, Im thinking about pulling the 67 rear end...- 4
- 112
-
bmcgc · updated
-
Hardware kits
Vintage Mustang ForumSo what hardware kits do You guys recommend and how is the quality and accuracy of these kits I saw the AMK kit but wasn’t sure about the accuracy and the quality!- 5
- 44
-
Bernnstang · updated
-
A/C install
Vintage Mustang ForumI am putting factory A/C in my '66. I have a couple of questions. What size bolt was used to attach the evaporator to the dash? How does one get safely get the caps off of the sanden compressor to hook the lines up to it? I need a drain hole cover for the interior, where can I get one of...- 0
- 0
-
Which brakes - consensus from the masses???
Vintage Mustang ForumLooking to get rid of PO front disc installation and replace with something better. Wilwood or Baer???? Or...??? What say ya'll???- 7
- 88
-
1966Stangman · updated
-
Wrap these Lungs?
Vintage Mustang ForumI am trying to limit the amount of heat transferring into my 1966 289 Fastback. I am considering Wrapping these burnt worn out pipes until I get ceramic coated headers. Should I just wrap them or is there a coating that I can apply to limit the cracking and rust that might develop because of the...- 19
- 491
Join now to ask and comment!