Will a dash pad from a 65 fit a 66?
1 - 3 of 3 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
65 temp guage problem.
Vintage Mustang ForumI have a 65 that I'm installing a 66 guage cluster. Tem guage stays to the left when the key is turned on. When engine is started and engine warms up guage goes all the way to the right towards hot. Longer it runs the further it goes until it is peged. Temp with thermoter reads 160. Fuel guage...- 1
- 15
-
Need help with rear U-joint size
Vintage Mustang Forum'66 coupe 289 w/ T-5 transmission. No idea if driveshaft is original. The one I bought ended up being too big (Moog 230 on rockauto, which was listed for a '66). Here are the measurements of what I need, measured with digital calipers: Axis A Bearing diameter 25.3mm Axis B Bearing diameter...- 9
- 185
-
What to do if you break down?
Vintage Mustang ForumI am specifically referring to having your car pulled up on a ramp truck? I have a 69 with a front spoiler and I am wondering how it it would be pulled up on the truck without at least damaging the front spoiler. Even without the spoiler wouldn't the cable run up against the front valence? I...- 22
- 728
-
Autolite 4100 question
Vintage Mustang ForumI’ve rebuilt a few 4100’s using the standard rebuild kits available from vendors and even the local auto supply stores. One thing I’ve always noticed that’s puzzled me in the exploded views is that the diagrams show a second check ball that fits between the upper part of the secondary diaphragm...- 1
- 87
-
erials · updated
-
Distressed-look or Patina Mustangs
Vintage Mustang ForumVMFrs, I just went through 68 pages of 1964-66 Mustangs sold at Mecum Auctions over the last many years. 99.9% of them were beautifully restored mustangs that looked brand new. What I realized though is that the distressed-look (patina or faux-patina) mustangs caught my eye big time! Pic 1...- 331
- 29K
-
evantugby · updated
Join now to ask and comment!