Vintage Mustang Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3,188 Posts
I bought the sets for my two cars at the Carlisle shows from one of the big wheel/lug nut/trim ring vendors, while not technically "correct", they worked just fine, believe I bought them for 14X6 rims, $40 for the set, also bought my lug nuts from them for 50 cents each, again they aren't technically correct, but I drive my cars and there not for serious show.In the 2-3 years they have been on the road I have never had anyone spot the differences in trim rings or nuts.
 

·
Registered
Joined
·
10,139 Posts
Not just "any" trim ring will fit but there are many that will.

You need a trim ring that will fit your 14x6 wheel with the same offset.
 

·
Registered
Joined
·
643 Posts
I found some generic trim rings at a swap meet for $4. They were perfect except for a small ding in one. They look good too even though they aren't original. For $4 I can't complain. I would then check a swap meet if there are any coming up. Justin
 
1 - 4 of 4 Posts
Top