Vintage Mustang Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Does the interior molding between the glass and the dash pad need to be installed before the glass goes on a 65 mustang.
 

·
Registered
Joined
·
8,913 Posts
No. The interior moulding is the very, very last thing installed...

Why explain, when you can just watch good videos and learn.... Grab some Popcorn and a Soda..


See here:


and here...

Part 1:



Part 2:



Outer Stainless Trim (After Windshield has been installed)...



Inner Trim...(Also linked with Dashpad install..)



Whew! That should do it!


:eek:)

Tony K.
 

·
Registered
Joined
·
931 Posts
No. The interior moulding is the very, very last thing installed...

Why explain, when you can just watch good videos and learn.... Grab some Popcorn and a Soda..


See here:

https://www.youtube.com/watch?v=w4igX1ZO5as&t=186s

and here..

https://www.youtube.com/watch?v=oWdSSa1Mzhs

and here...

Part 1:

https://www.youtube.com/watch?v=vr7Prioj9Xo


Part 2:

https://www.youtube.com/watch?v=zY_b6838A8g


Outer Stainless Trim (After Windshield has been installed)...

https://www.youtube.com/watch?v=uqGf5bs4FUE


Inner Trim...(Also linked with Dashpad install..)

https://www.youtube.com/watch?v=-Et2jEhDYWY


Whew! That should do it!


:eek:)

Tony K.
Thanks for taking the time to post those. I need to do my windshield soon too.
 

·
Registered
Joined
·
462 Posts
One thing none of the videos show or tell is to wash the rubber gasket with soap and water to remove the rubber mold release agent (powder) that is on the gasket... this allows the gasket to be removed from the die in which it is made but can keep other "sealants" from doing their job...I washed mine off in the bathtub with Dawn and then dried, followed up with an alcohol swap to remove any residue...Hope this helps.
 
1 - 5 of 5 Posts
Top