Windshield washer

507 Views 5 Replies 2 Participants Last post by Nick66, Jun 17, 2002

Nick66

Discussion Starter · Jun 17, 2002

Hello all.

Ive recently learned that my car was originally equipped with a windshield washer system.
Since obviously it isnt there anymore, I thought of installing one again.
Ive alredy looked into the NPD catalogue, and there is a sketch of the system.
It looks like its a difficult task, as the nozzles seem to go into the cowl area?!

How hard is it to get the nozzles/the system installed?
Just like to get an idea about the job...! /forums/images/icons/smile.gif

Thanks,
Nick

Save

1 - 6 of 6 Posts

· #2 · Jun 17, 2002

Not hard at all. The tubes are pre-formmed and extend in from under the hood and held on with a clip and screw.If the holes are there, it should just mount right up. The washer bag and bracket mount right to the inner fender, the pump goes right below it. Should be simple install. If you want pics of an original system installed, let me know.

Save

Nick66

Discussion Starter · #3 · Jun 17, 2002

So the nozzles arent hard to install?
Ive noticed that, as youve mentioned, even the hoses are pre cut and just need to get installed along the other components. I was worrying about the nozzles though as I dont really have a clue where they go.
The cowl seems to be hard to access! /forums/images/icons/wink.gif

Yes, I definately would like pictures if you have any. Just to get some idea about the set up. /forums/images/icons/smile.gif

Thanks!

Save

· #4 · Jun 17, 2002

I'll take them tonight and send them to your e-mail.

Save

Mudcat

· #5 · Jun 17, 2002

There should be access holes in the cowl just below the hood. The nozzles just slip through.

Save

Nick66

Discussion Starter · #6 · Jun 17, 2002

Thanks a bunch! /forums/images/icons/smile.gif

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month