Vintage Mustang Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I have replaced the firewall on a 67 coupe and am looking for info on the metal studs that hold the wiring harness. They are similar to the studs used to hold the windshield trim clips. I guess I could cut them out of the old firewall. Anyone have any suggestions?
 

·
Registered
Joined
·
35,830 Posts
A good body shop would have a stud gun for welding these on. Basically, though, it's just a nail head. Drill a small hole, shorten a nail, and weld it on from the back. No one will know it's not factory.
 
1 - 3 of 3 Posts
Top