Woodward Dream Cruise | Vintage Mustang Forums

1 - 1 of 1 Posts

jsgarron

·

Registered

Joined Feb 18, 2001

·

781 Posts

Discussion Starter • #1 • Aug 16, 2002

Oh Boy the Woodward Dream Cruise starts today (offically). What a site, thousands upon thousands of the hottest vintage cars you ever can imagine. The sounds that emanate from Woodward all day are enough to make you wet your pants. I have been to a lot of show but I am telling you this is the Mack Daddy of the muscle car shows. If you cant be there watch for it on the news, it will be a blast.

1 - 1 of 1 Posts

Recommended Reading

66 Front Bumper Fitment

Vintage Mustang Forum

So I install a reproduction front bumper on my 66 coupe. This car is mostly repro front end parts and I have been working on it for 12 years (since complete disassembly). The original parts were damaged beyond repair so at the end of this epic street car "Frankenstang" build the bumper has large...
- 3
- 37
- Rudedog289 · updated a moment ago
Parts ID help please

Vintage Mustang Forum

I have some parts that came with my car that I'm finally getting to Not sure if these are special and wondering what the little plate is over the primary booster on the carb... Cam is still in sealed plastic.
- 2
- 37
- rtate · updated a moment ago
Contemplating Reupholstering My 66 Mustang Seats--Advice

Vintage Mustang Forum

I have a 66 mustang convertible and I am contemplating installing the new upholstery and seat foams myself. Anyone have any good videos or links to videos that have pointers to help me through this process. Thanks
- 32
- 651
- S
  sleeton · updated 18 m ago
Sheet Metal Alignment

Vintage Mustang Forum

A couple questions: The tops of my fender aprons where the fenders bolt on are a bit wavy. Should these surfaces be flat? The top of my radiator core support bends in slightly toward the firewall. Should the top of the core support be straight?
- 3
- 43
- bmcgc · updated 20 m ago
Freeze plug question

Vintage Mustang Forum

So I have a 65 mustang with a 289 and the freeze plugs on the front side of the cylinder heads went out and leaked. Now these plugs are brass and about 5/8” deep, which I’m sure didn’t come on the engine stock. I figured I might as well just replace both of the front ones. I went to about every...
- 2
- 24
- Aaron65shelby · updated 23 m ago