Vintage Mustang Forums banner
  • Hey everyone! Enter your ride HERE to be a part September's Ride of the Month Challenge!
1 - 2 of 2 Posts
G

·
Discussion Starter · #1 ·
To put one washer spacer inbetween bellhousing and engine? Reason I'm doing this is to get exactly 1/8 inch for clearance flexplate to torque converter. I am 99.99% sure I have torque converter in properly (3 clicks) but when I bolt up the bellhousing it dosent give me the proper end play needed (1/8), the washer spacers make it perfect (just one per bolt not a big stack).
 
1 - 2 of 2 Posts
Top