[Haymore1965]

Ok so i installed LED front Turn Signals and an LED flasher. My lights work in the rear correctly, but at the front, both turn signal lights are blinking. What could be an issue there?

Also, installed new turn signal cancellation switch under steering wheel and it feels like after i turn the wheelabout 180 degrees, it cancels. Is it just me or should it be engaging longer than that?

 

[Kid Mechanic]

It's being grounded out. Check your wires, they can get brittle and crack, and you were just doing work in that area. One possibility.

 

[Woodchuck]

Do you have a '65 with a "Falcon Cluster"? If so, the issue is in the indicator lamp, which bridges both front turn signal circuits. You'll probably have to install some additional load resistors on each front t/s circuit.

 

[Haymore1965]

Yes i do have a Falcon Cluster. SO since i dont have a light in the turn signal socket, thats what causing it?

 

[Woodchuck]

Yes i do have a Falcon Cluster. SO since i dont have a light in the turn signal socket, thats what causing it?

You don't have an indicator bulb? That could do it.

 

[Haymore1965]

I took it out for some reason and i never put one back in. I shall try that in a few and see how that works. Would it matter if the bulb is burnt?

 

[gtonavy]

Hello Heymore

The single will not work correctly with LEDs if you use the stock incandescent bulb.

The filament of the bulb actually connects both the right and left side together.

Found this out the hard way on a customers 64 1/2.

You will need a special LED bulb with blocking diodes to isolate the right and left side from each other.

Actually if yo pull the indicator bulb, the front park/turn lights should function correctly.

PM me if you need any help.

Gary

Where did you get the park lights?