I have a 3.03 tranny with a 6.5” long, 10 spline, 1 1/16” diameter input shaft. This is for my ‘66 200 engine. The shaft isn’t long enough to go into the pilot bearing. It should be about 1/2” longer. Is there a longer input shaft for this application? Thanks for the help in advance.
Jamstang
The length sounds correct. Are you using a '67+ bellhousing? If it truly IS a bit short, you can use a wider pilot bearing... a 6203-ZZ is 10mm wide, a 63003-2RS1 is 14mm wide and a NAO 17X35X16 is 16mm wide.
Yes there is a long and short input shaft. The end of the shaft that goes in the bearing is longer on the small block and shorter on the big block. About 1/2". You could have a big block input?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
