ok, im upgrading to a non-power front dic brake setup on my 66 and im planning to use a 67 dual master cylinder. so what fluid distribution block do i need?
67 distribution block
sfw88
1 - 1 of 5 Posts
Joined
·
733 Posts
What MC are you planning to use? Is this the Granada disc swap? if so look here http://www.mustangsteve.com/granadadiscs.html
IF Not:
My best guess would be a 67 Disribution block that was used on a Disk brake equipped car(and make sure you get the short lines connected to the distrubution block). You will also need a brass adapter fitting from Napa Auto Parts to connect rear brake line (can't remember which P/N) I think you will also have to use the pushrod from the 66 MC for your 67 MC.
IF Not:
My best guess would be a 67 Disribution block that was used on a Disk brake equipped car(and make sure you get the short lines connected to the distrubution block). You will also need a brass adapter fitting from Napa Auto Parts to connect rear brake line (can't remember which P/N) I think you will also have to use the pushrod from the 66 MC for your 67 MC.
1 - 1 of 5 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
