[NitroGe0]

I am doing a Transmission swap in a 1968 Coupe with a 302 motor Going from the C3 to a T5 and plan to use an aluminum drive shaft out of a 2000 4 door 2wd explorer. I'll be using a 28 spline ford racing slip yoke and the stock rear end.
What universal joint do I use to connect this drive shaft to the rear end?
Thanks a bunch!

 

[Flade]

You have to measure the yoke and driveshaft to determine the diameter needed for each. You also need to confirm if each side uses an inner clip our outer clip. Once you have that info, you can look up the correct U-joint

 

[NitroGe0]

Flade, you are always a great source of good information. I really appreciate your input. Thanks

 

[JW67Conv]

This might help, it has the part numbers I used. I swapped the front yoke as noted.

Double check the part numbers work for you

https://www.vintage-mustang.com/threads/swapping-a-ford-explorer-driveshaft-into-a-1967-1968-mustang.1216295/?post_id=10856721#post-10856721

 

[Huskinhano]

You want a 1310/1330 combination. They’re common and any halfway decent parts store should have them.

Spicer U-Joint 5-134X

Shop for Spicer U-Joint 5-134X with confidence at AutoZone.com. Parts are just part of what we do. Get yours online today and pick up in store.

www.autozone.com

 

[NitroGe0]

This might help, it has the part numbers I used. I swapped the front yoke as noted.

Double check the part numbers work for you

https://www.vintage-mustang.com/threads/swapping-a-ford-explorer-driveshaft-into-a-1967-1968-mustang.1216295/?post_id=10856721#post-10856721

This might help, it has the part numbers I used. I swapped the front yoke as noted.

Double check the part numbers work for you

https://www.vintage-mustang.com/threads/swapping-a-ford-explorer-driveshaft-into-a-1967-1968-mustang.1216295/?post_id=10856721#post-10856721

Thanks for the info JW67Conv

 

[NitroGe0]

This might help, it has the part numbers I used. I swapped the front yoke as noted.

Double check the part numbers work for you

https://www.vintage-mustang.com/threads/swapping-a-ford-explorer-driveshaft-into-a-1967-1968-mustang.1216295/?post_id=10856721#post-10856721

You want a 1310/1330 combination. They’re common and any halfway decent parts store should have them.

Spicer U-Joint 5-134X

Shop for Spicer U-Joint 5-134X with confidence at AutoZone.com. Parts are just part of what we do. Get yours online today and pick up in store.

www.autozone.com

Thanks for the info Huskinhano