1964 1/2 has the virus (won't start)!

must · Apr 8, 2020

I have a starting problem with my 1964 1/2 mustang. The starter turns over but the car won't start. It is getting gas. I've done a tune up on it with new spark plugs, wires, cap, and rotor, and starter solenoid (I tried 3 different coils too). There is power getting to the coil, but no spark coming out of the high tension lead from the coil. I even pull out the protonix ignitor and put new points back in but no spark. This all started about two weeks ago when I was driving the car and noticed the car had no power when accelerating. I checked the timing and then this happened that the car wouldn't start. Is there anything else I could inspect like maybe the ignition switch etc?

Thank you,

myfirstcar66 · Apr 8, 2020

Check for clean connections at the I and S small poles on the solenoid switch, good ground in the distributor and from the block or back of the head to the firewall.

Nailbender · Apr 8, 2020

Too soon.

Woodchuck · Apr 8, 2020

Bart's first rule of engine diagnosis is???

Cranking compression test.

kenash · Apr 8, 2020

What is the history of this engine? That is, Did it crank and fire at some point in the past? What work have you performed besides the timing check?

ophthos · Apr 9, 2020

I'm going thru the same thing. I think my Pertronix is fried. They sent me a link on how to test the unit.

Also you can look at a thread I have. Some great info on ruling out certain areas: VMF thread.

Do you have the Flamethrower coil? If so can you use a 1.5 ohm coil with points? Don't know if it matters so I'm throwing the question out.

If I figure mine out, I'll let you know.

1964 1/2 has the virus (won't start)!

Attachments

Our Vendors

Top Contributors this Month

Recommended Communities